|
|
 |
 |
|
|
UJV-160 |
| Head |
On-demand Piezo head |
| Print resolution |
600 dpi, 1200 dpi |
| Ink |
UV curable ink (both flexible and hard types are available) |
| 5 color: C,M,Y,K,W / 1,200 ml (600 ml × 2 cartridge)/color |
| Maximum print width |
Roll: 1,610 mm (63.3 "), Rigid: 1,600 mm (63.0 ") |
| Media |
Width |
1,620 mm (63.7") |
| Thickness |
Max. 10 mm (0.39") |
| Weight |
Roll: less than 25 kg (55 lbs.) |
| Rigid: less than 12 kg (26.4 lbs.) |
| Roll diameter |
Inside: 2 inch, 3 inch / Outside: Less than φ180 mm (7.1") |
| Media cutting |
Manual cutting |
| UV device |
Equipped with UV Light Emitting Diodes |
| Media heater |
Pre / print heater |
| Media take-up device |
Roll take-up device (Standard), inside / outside selectable |
| Interface |
USB 2.0 |
| Applicable standard |
VCCI class A, UL60950-1, FCCI class A,
CE marking (EMC directive, low voltage directive),
CB report, RoHS |
| Power specifications |
AC 100 V – 120 V, 200 – 240 V ± 10 %, 50 – 60 Hz ± 1 Hz,
less than 1.68 KVA |
| Operational environments |
Temperature |
15°C – 30°C |
| Humidity |
35 – 65 % Rh (No condensation) |
Dimensions
(W x D x H) |
Main unit |
3,300mm x780mm x 1,290mm (129.9" x 19.8" x 50.7") |
Main unit
+ media stand |
3,300mm x 4,300mm x 1,290mm (129.9" x 169.3" x 50.7")
(Main unit and table with support wire) |
| Weight |
Main unit |
260 kg (573 lbs.) |
| Media table |
50 kg (110 lbs) x 2 units |
|
|
Some of the samples in this catalogue are artificial renderings. |
|
|
Specifications, design and dimensions stated in this catalogue may be subject to change without notice (for technical improvements, etc). |
|
|
The corporate names and merchandise names written on this catalogue are the trademark or registered trademark of the respective corporations. |
|
|
Inkjet printers print using extremely fine dots, so colors may vary slightly after replacement of the print heads. Also note that if using multiple printer units, colors could vary slightly from one unit to the other due to slight individual differences. |
 |
Inks and substrates: |
|
|
| · |
Please note that properties and adhesion, weather resistance etc. of ink and substrates can vary. Therefore please test materials before printing. |
| · |
Some substrates require primer before printing. Please test materials beforehand or ask your sales representative. |
|
Safety notice: |
|
|
You are dealing with UV light sources that may harm your health.
Please follow below guidelines strictly: |
|
| · |
Do not look directly into the UV light source nor place your hand, or expose your skin directly to the UV light source. |
| · |
Depending upon print mode, there might occur some VOC emittance from printed parts not yet cured and hardened. |
| · |
In addition, please read the instructions and guidelines of the manual carefully and follow those. |
|
|
