|
|
 |
 |
|
|
UJF-605RII
|
| Print head |
Piezo-electric drop, on-demand
|
| Resolution |
300×300dpi, 600×600dpi, 1,200×1,200dpi, 1,200×2,400dpi |
| Ink |
Original UV-curable ink (YMCKLmLc + White)
400cc ink cartridge for each color
|
| Max. Printing Width |
600×500mm (23.6"×19.7")
|
| Distance Accuracy |
Absolute accuracy |
0.1mm (0.0039")or less
|
| Repeatability |
±0.2mm (0.0078")or less |
| Perpendicularity |
0.5mm / 500mm (0.0196" / 19.6")
|
| Waste Ink Tank |
Bottle type (2 liters)with sensor
|
| Media Size |
Roll |
Maximum width: 640mm (25.20")
Minimum width: 150mm (5.91")
Weight: less than 25kg (55.0lbs.)
|
| Cut Sheet |
640×520mm (25.20"×20.47")
|
| Media thickness |
Roll |
0.02 to 0.2mm |
| Cut Sheet |
0.02 to 2.0mm |
| Media Set Device |
Suction by air vacuum
|
| UV Device |
Equipped with UV lamp
|
| Interface |
IEEE1394/IEEE1284
|
| Applicable standard |
VCCI Class A, FCC Class A, ETL (UL 60950),
CE Marking (EMC Directive, Low Voltage Directive),
CB report, RoHS Directive
|
| Power specification |
Printer main unit / UV device, single-phase 200V-240V, 20A
|
| Power Consumption |
4.0KVA or less
|
Operational
Environment |
Temperature |
15°C to 30°C (60°F to 80°F)
|
| Humidity |
35% to 65% Rh
|
Guaranteed
temperature |
18°C to 25°C (65°F to 77°F)
|
| Dust |
Equivalent to normal office level
|
| Wight |
795kg (1,751lbs.)or less
|
Outside Dimensions
(W×D×H) |
2,340×1,920×1,530mm (92.1"×75.6"×60.2")
|
 |
Inks and substrates: |
|
|
| · |
Please note that properties and adhesion, weather resistance etc. of ink and substrates can vary. Therefore please test materials before printing. |
| · |
Some substrates require primer before printing. Please test materials beforehand or ask your sales representative. |
|
Safety notice: |
|
|
You are dealing with UV light sources that may harm your health.
Please follow below guidelines strictly: |
|
| · |
Do not look directly into the UV light source nor place your hand, or expose your skin directly to the UV light source. |
| · |
Depending upon print mode, there might occur some VOC emittance from printed parts not yet cured and hardened. |
| · |
In addition, please read the instructions and guidelines of the manual carefully and follow those. |
|
|
