|
|
Optimum high-power cutting ability for a thick and hard materials. |
|
|
|
The maximum 25kg cutting pressure is available, and a thick material (up to 10mm thickness) can be set. Enables flexible cutting on various materials, such as commercial rubber, rubber plate, and joint sheet by the tangential control. Additionally, air suctions prevents a material from floating when cutting off. |
|
|
Automatic blade control function improves working efficiency. |
|
|
|
Cutting depth is changeable from the operation panel or by executing command in case of cutting the various thickness materials. Perform multiple cutting operations as changing the cut depth for each material. |
|
|
|
|
|
High reliability and the cutting accuracy |
|
|
|
Four-circle( X·Y·Z·θ) software-servo control enables the CF series to plot straight lines without distortion or overshoot with its high reliability and the rigidity by the pole screw drive. For a better workmanship, use the swivel compensation function to adjust the swivel blade cutter holder in the software. |
|
|
Equipped with a mechanism to fully-hold a work |
|
|
|
A mechanical clamp jig and air suction are equipped on a cutting panel to hold a work. These equipments enables easy fix/release of the materials on the panel. Additionally, a plate is equipped to protect a cutter blade when performing die cutting. |
|
|
Achieved high-quality cutting with advanced technologies |
|
|
|
The advanced functions, such as Offset of start and end points, Pressure compensation, Circleθcorrection, and Multi-pass plot enables high quality cutting. |
|
|
An area sensor and a nicked edge sensor are option |
|
|
|
We provide you an area sensor (prevents tools from crashing into obstacles besides works on a cutting panel) and a nicked edge sensor (detects a miss cut operation by a blade with a nicked edge) as option. |
|
|
| Available materials |
|
| · |
Joint sheet / Asbestos (Less than 3mm) |
| · |
Joint sheet / Non-Asbestos (Less than 3mm) |
| · |
Fluorocarbon resin sheet(Less than 5mm) |
| · |
Commercial rubber
| · |
Nytrill rubber (Less than 10mm) |
| · |
Silicon rubber (Less than 10mm) |
| · |
Fluorosis rubber (Less than 10mm) |
| · |
Polyurethane rubber (Less than 10mm) |
| · |
Cloth-inserted rubber (Less than 7mm) |
|
| · |
Soft polyvinyl (Less than 10mm) |
| · |
Rigid polyvinyl (Less than 1mm) |
| · |
Polycarbonate (Less than 1mm) |
| · |
Artificial leather (Less than 3mm) |
| · |
Coated board (Less than 2mm) |
| · |
Paste board (Less than 2mm) |
| · |
Cardboard (Less than 10mm) |
| · |
PET film (Less than 1mm) |
| · |
Masking rubber for sandblasting (Less than 3mm) |
| · |
Resin conveyor belt (Less than 5.0mm) |
| · |
Styrene board (Less than 10mm) |
|
| *Cutting condition may differ depending on the material or the thickness. Ask for details. |
|
 |
|
CFS-head
A-station: Swivel blade / Pen (20-200g)
A-station: Swivel blade / Pen (20-200g) |
|
|
C-station: Very high-pressure tangential cutter (1,000-25,000g) |
|
