|
|
 |
 |
|
| The CF3 is supplied with the high performance cutting software, Mimaki Plotter Assistant and FineCut7. Cutting data is created with FineCut7. The cutting conditions are set up and the status of the plotter is monitored with the Plotter Assistant software. These software applications enable full utilization of the capabilities of the CF3. |
|
| The Mimaki Plotter Assistant software controls the CF3 from a PC and monitors the status. Set-up and adjustment of the required cutting conditions is easily done using the wizard feature. |
Status guidance function
This function enables you to monitor the status and ensures consistent cutting.
Wizard function
Following the simple steps in the wizard, set-up and adjustment of the required cutting conditions are easily achieved and ensure a successful cutting job.
Cutting condition function
|
|
The cutting condition for each material and thickness in the software can be saved for later set-up of the cutting condition directly to CF3. |
|
|
|
|
The suitability of a cutting condition can be checked with the "Test Cut" function. |
|
|
|
|
It is possible to write and store any cutting condition in the cutting condition file of FineCut7. |
|
|
 |
 |
 |
|
|
FineCut7 utilizes the capabilities of the CF3 to the fullest. The software optimizes the cutting performance: direction, speed, start position, cutting order and cutting depth. The software is used as a plug-in for CorelDRAW and Illustrator.
Cutting function optimized for the router
The cutting function optimizes the cutting position with the router head. This function ensures proper cutting.
Final pass control
The last part of the pass is not cut in full to keep the material from shifting. This is done at a later stage with low force.
Cutting preview function
Before starting to cut, the cutting line, cut direction, and cutting order, etc. can be checked. This ensures a successful cutting job.
 more |
|
|
|
