|
|
 |
| * |
Your Mimaki dealer or Mimaki sales office will advise you of the suitability of specific materials that you would like to cut. |
| Supports both small and large size media up to 1.6m x 3.1m (63" x 122"). Even difficult acrylic or aluminum composite panels can be cut with consistently high accuracy. User exchangeable cutting heads to suit a wide range of conditions widen your possibilities greatly. |
 |
|
| The M head is used exclusively for router cutting.
With a high-speed spindle, rigid materials such as acrylic or aluminum composite panels can be cut easily, even up to 50mm in thickness.
|
|
| The cut depth control function enables multiple cuts for especially thick materials. |
|
 |
|
| Spindle speed |
60,000rpm |
| Tool chuck |
collet type |
| Maximum tool diameter |
6mm (0.24") |
| Main materials |
rigid materials such as acrylic and aluminum composite panels |
| Set tool |
endmill |
 |
|
| Thick materials up to 20mm (0.78") can be cut with the reciprocating cutter. The R1 head is equipped with a material-holding unit, which prevents cut materials from lifting. The cutting head is suitable for cutting corrugated boards and foam materials. |
|
|
Maximum
reciprocating speed |
approximately 10,000 strokes/min |
| Stroke |
1mm *dependent on the cutter and holder used |
| Maximum cut depth |
20mm *dependent on the cutter and holder used |
| Main materials |
cardboard, corrugated board, foam material |
| Set tool |
swivel cutter/pen, reciprocating cutter creasing tool, high-pressure tangential cutter |
 |
|
| The tangential cutter steers the blades as it cuts. With two types of tangential cutters and fine cut pressure settings a wider range of materials can be cut successfully. Various cutting tools are provided for a range of materials. Any suitable blade available on the market, can be mounted. |
|
|
| Vertical tool force |
low-pressure head:300-1,500,
high-pressure head:1,000-5,000g |
| Main materials |
reflective sheet, rubber, industrial materials |
| Set tool |
swivel cutter/pen, tangential cutter creasing tool and high-pressure tangential cutter |
|
|
