|
|
 |
| ● |
Possible to perform an on demand production quickly responding to an order even as small as 1 piece. |
| ● |
You can perform from sample making to short-run production, as you like. |
| ● |
Mark sensor function enables you to make precise contour cutting of printed materials. |
| ● |
Creasing tool produces optical creases in carton and corrugated board. |
By reciprocating the cutter up and down at high speed, even thick material can be cut.
The material that can be cut has been further extended including double-faced corrugated board. |
|
 |
|
 |
By attaching special mark chips, it is possible to perform cutting, drawing of ruled lines and folding lines from the back surface.
The mechanism is that the sensor reads the center of the chip and cut. (FineCut is used.) |
|
 |
|
 |
| Head |
Tool |
Pressure |
remarks |
| TD |
A |
Pen / swivel cutter |
20-400g |
|
| B |
Tangential cutter |
300-1,500g |
|
| C |
Marking gauge roller |
1,000-5,000g |
|
| RC |
A |
Pen / swivel cutter |
20-400g |
|
| B |
Reciprocal cutter |
1,500g fixed |
Stroke 2 mm Maximum
vibration 7,000 times |
| Tangential cutter |
500-1,500g |
|
| C |
High-pressure tangential
cutter / Creasing tool |
1,000-5,000g |
|
|
|
